Siemens SITRANS FC330 - Turning the Transmitter (Compact Version)

3. From the front of the panel:
– Insert housing in cut-out hole.
4. From the back of the panel:
– Mount mounting bracket on transmitter housing using four hex socket screws (M6 x 60
or equivalent), four hexagon nuts (M6) with flanges, a 5 mm Allen key, and a 10 mm
wrench.
5. Use four hex head screws (M8 x 100), four hexagon nuts (M8), and two wrenches (13 mm);
and repeat the following for each of the four mounting screws:
– From front side of mounting bracket: Put screw ① into one of the outer holes.
– From back side of mounting bracket: Screw nut ② on screw.
– Bolt until screw lies against panel wall.


6. Tighten screws.
7. Remount lid.
4.2.1.3 Turning the transmitter (compact version)
Horizontal rotation
1. Unscrew cap from lock screw.
2. Loosen lock screw at transmitter pedestal using 5 mm Allen key.
Installing/mounting
4.2 Installation instructions
SITRANS FC330
Operating Instructions, 01/2019, A5E44030648-AB 45