Siemens SITRANS FC330 - Page 73

Connect wires
1. Remove cap and ferrule from cable gland and slide onto cable.
Wall mount enclosure: Remove blind plug and fit cable gland.
2. Push cable through open gland and cable path.
3. Restore ferrule and tighten cap to lightly hold cable in place.
4. Fold signal cable screen back over outer sheath and ground beneath cable clamp.
In case of shielded cables, use metal cable glands for proper connection.
5. Connect wires to terminals using screwdriver.
6. Tighten cable gland.
The numbers in the graphics below refer to table Figure 5-3 Termination/configuration overview
(Page 67).
If connected as input or output - Field mount
11
12
12
13
Active configuration Passive configuration
⑫ IO[3] (common) ⑬ IO[3]- (passive)
⑪ IO[3]+ (active) ⑫ IO[3] (common)
Functional Earth Functional Earth
Table 5-1 If connected as input or output - Wall mount
)




)




Active configuration Passive configuration
Connecting
5.2 Connecting FC330
SITRANS FC330
Operating Instructions, 01/2019, A5E44030648-AB 73