Siemens SITRANS P - Page 103

Calibration SIMATIC PDM Device with display (lo‐
cal operation)
Device without display
(local operation)
Correct the zero point error Menu command "De‐
vice > Zero point ad‐
justment"
Zero point adjustment
[07] (Page 119)
Commissioning the de‐
vice without display
(Page 11
)
Sensor calibration Menu command "De‐
vice > Sensor calibra‐
tion"
- -
Apply lower range value
Apply upper range value
Menu command "De‐
vice > Apply values"
Apply lower range val‐
ue parameter [08]
(Page 122
)
Apply upper range val‐
ue parameter [09]
(Page 122)
Commissioning the de‐
vice without display
(Page 11)
Simulation SIMATIC PDM Device with display (lo‐
cal operation)
Device without display
(local operation)
Simulate fixed pressure value / simulate ramp Menu command "De‐
vice > Simulation >
Process values"
- -
Identification SIMATIC PDM Device with display (lo‐
cal operation)
Device without display
(local operation)
Read and configure identification data of your
device
"Identification" param‐
eter group
- -
Maintenance and diagnostics SIMATIC PDM Device with display (lo‐
cal operation)
Device without display
(local operation)
Read diagnostic log Menu command "De‐
vice > Diagnostic log"
- -
Display of the diagnostics Menu command "Diag‐
nostics > Diagnostics"
Diagnostics and trou‐
bleshooting (Page
189)
-
Simulate diagnostics Menu command "De‐
vice > Simulation > Di‐
agnostics"
- -
Limit monitoring and event counter Menu command "De‐
vice > Limit monitoring
and event counter"
- -
Device maintenance, sensor maintenance, serv‐
ice, calibration
Menu command "Main‐
tenance"
- -
Display operating time
Operating hours counter
(Page 158
)
Menu command "Diag‐
nostics > Device state
> HART status"
- -
Parameter assignment
9.1 Overview of parameters and functions
SITRANS P320/P420 with 4 to 20 mA/HART
Operating Instructions, 11/2019, A5E44852162-AC 103