Maintenance and diagnostics SIMATIC PDM Device with display (lo‐
cal operation)
Device without display
(local operation)
Set peak values
Reset peak values
"Maintenance and di‐
agnostics > Peak val‐
ues" parameter group
Menu command "De‐
vice > Reset peak val‐
ues"
- -
Configure trend log
Show trend log
Menu command "De‐
vice > Trend log set‐
tings"
Menu command "Diag‐
nostics > Trend log"
- -
Display number of measuring cells or measuring
transducer electronics replacement
Parameter group
"Maintenance and di‐
agnostics
>
Audit trail >
HW exchange counter"
- -
HART communication SIMATIC PDM Device with display (lo‐
cal operation)
Device without display
(local operation)
Configure HART address Menu command "De‐
vice > Assign address"
- -
Set the loop current value in multidrop mode "Settings > Current out‐
put > Loop current val‐
ue in multidrop mode"
- -
Enable or disable the device identification via
HART command "Find device"
- Identify the device [34]
(Page 143
)
-
Select secondary variable (SV) "Settings > Select out‐
put > SV selection" pa‐
rameter group
SV selection [15]
(Page 127)
-
Select tertiary variable (TV) "Settings > Select out‐
put > TV selection" pa‐
rameter group
- -
Select quaternary variable (QV) "Settings > Select out‐
put
>
QV selection" pa‐
rameter group
- -
Write protection SIMATIC PDM Device with display (lo‐
cal operation)
Device without display
(local operation)
Enable and disable user PIN Menu command "De‐
vice > Security"
User PIN [27]
(Page 138)
-
Change user PIN Menu command "De‐
vice > Security >
Change user PIN"
Change user PIN [24]
(Page 135)
-
Display Recovery ID Menu command "De‐
vice > Security > PIN
recovery"
Recovery ID [25]
(Page 136)
-
Parameter assignment
9.1 Overview of parameters and functions
SITRANS P320/P420 with 4 to 20 mA/HART
104 Operating Instructions, 11/2019, A5E44852162-AC
To Next Page
Loading...
