Reset SIMATIC PDM Device with display (lo‐
cal operation)
Device without display
(local operation)
Restore ordered configuration Menu command "De‐
vice > Reset > Restore
ordered configuration"
Restore ordered con‐
figuration (Page 141)
-
Factory reset Menu command "De‐
vice > Reset > Factory
reset"
Restore factory set‐
tings (Page 141)
-
Reset to sensor calibration Menu command "De‐
vice > Reset > Reset to
sensor calibration"
Reset to sensor cali‐
bration (Page 140)
-
Functional Safety
The following additional functionality is available for devices with Functional Safety:
Functional Safety SIMATIC PDM Device with display (lo‐
cal operation)
Device without display
(local operation)
Enable and disable Functional Safety Menu command "De‐
vice > Functional Safe‐
ty"
Functional Safety [29]
(Page 136)
-
9.2 Parameter assignment over device with display
Introduction
This section describes all parameters that you can reach over the device with a display.
You will find information on operating the device with display in the section Operating the device
with display (Page 70).
You can find the list of available parameters with ID and parameter name in the section List
of parameters on the display (Page 74).
9.2.1 Pressure units [01]
Introduction
With the "Pressure units" [01] parameter, you select the unit of the "Pressure" (P1) measured
value that is displayed in the measurement view.
You can find a description of the pressure units that you can set in the section Display of the
pressure units (Page 102).
With the "Pressure reference" parameter [33], you adapt the display of the pressure units to
your application, if necessary (absolute pressure or gauge pressure).
Parameter assignment
9.2 Parameter assignment over device with display
SITRANS P320/P420 (mA/HART)
Operating Instructions, 06/2018, A5E44852162-AA 101
To Next Page
Loading...
