Siemens SITRANS Series - Introduction; 2.1 Purpose of this documentation; 2.2 Document history; 2.3 Product compatibility

Introduction
2
2.1 Purpose of this documentation
These instructions contain all information required to commission and use the device. Read
the instructions carefully prior to installation and commissioning. In order to use the device
correctly, first review its principle of operation.
The instructions are aimed at persons mechanically installing the device, connecting it
electronically, configuring the parameters and commissioning it, as well as service and
maintenance engineers.
2.2 Document history
The overview below summarizes the most important changes in the documentation when
compared to the previous edition.
Edition Note
06/2018 First edition
2.3 Product compatibility
The following table describes the compatibility between the edition of this manual, the device
revision, the engineering system and the associated EDD.
Edition Comments Product compatibility Compatibility with device integra‐
tion package
06/2018 First edition HART 7
FW: 1.00.08 or higher
HW: 1.00.00 or higher
Device version 1
SIMATIC PDM V9.0 or higher
AMS Device Manager V13 or high‐
er
DTM Pactware V4.1 SP4
FC475 V3.9 or higher
2.4 Scope of validity of this document
Variant SITRANS P320 mA/HART SITRANS P420 mA/HART
Gauge pressure 7MF0300 7MF0400
Gauge pressure from the differential
pressure series
7MF0310 7MF0410
Absolute pressure from the gauge pres‐
sure series
7MF0320 7MF0420
SITRANS P320/P420 (mA/HART)
Operating Instructions, 06/2018, A5E44852162-AA 15