5.2.3 Fastening with the mounting bracket
Introduction
You mount the pressure transmitter with the mounting bracket as described below:
● On a mounting range
● On a vertical or horizontal pipe (Ø 50 to 60 mm)
When securing, observe the torques in the section Torques (Page 229).
Note
Install the device so that the pressure transmitter and the differential pressure lines are not
subject to different vibrations. Otherwise there is a danger that the differential pressure lines
will rupture.
Example 1: Pipe mounting of pressure transmitter (gauge pressure series)
The mounting bracket for the gauge pressure series includes, among other things:
● 2 screws
● One pipe clamp with nuts
● Washers
Mount the pressure transmitter as follows:
Example 2: Pipe mounting of pressure transmitter (differential pressure series)
The mounting bracket for the differential pressure series includes, among other things:
● 4 screws
● One pipe clamp with nuts
● Washers
Installing/mounting
5.2 Installation (except level)
SITRANS P320/P420 (mA/HART)
Operating Instructions, 06/2018, A5E44852162-AA 45
To Next Page
Loading...
