Siemens SITRANS Series - 7.2.4.2 Navigating in the parameter view; 7.2.5 Edit view

7.2.4.2 Navigating in the parameter view
Requirement
The button lock is disabled.
Disabling button lock (Page 131)
Procedure
1. Use the
or buttons to navigate within the parameters.
To navigate faster, keep the or button pressed.
After the last parameter, you jump to the first parameter, and vice versa.
2. To switch to edit view, press the button.
3. To return to the measurement view, press the button.
7.2.5 Edit view
You change the parameter values in the edit view. Wizards are available for specific
parameters.
Parameter values
There are various parameter values:
● Enumerations (e.g. unit)
● Numerical values (e.g. damping)





① Name of parameter and, if availa‐
ble, unit (alternating)
④ "EDIT" symbol (flashing)
② Enumeration arrows (for enumera‐
tions only)
⑤ Parameter value
③ Parameter ID
Figure 7-5 Example of edit view
For parameters with an associated unit, the parameter name and unit are displayed as
alternating values in ①. Example: Lower range value in mA.
Operating
7.2 Operating the device with display
SITRANS P320/P420 (mA/HART)
76 Operating Instructions, 06/2018, A5E44852162-AA