Siemens SITRANS Series - 9.2.14.4 Mass flow units [16]

Certain units are displayed differently on the display and over remote operation. (Page 102)
Setting range: Display (header line) Display (enumeration) Remote operation
m3/sec m3/S m³/s
m3/min m3/m m³/min
m3/h m3/h m³/h
m3/d m3/d m³/d
l/Sec l/S l/s
l/min l/m l/min
l/h l/h l/h
Ml/d Ml/d Ml/d
FT3/Sec Ft3/S ft³/s
Ft3/min Ft3/m ft³/min
Ft3/h Ft3/h ft³/h
Ft3/d Ft3/d ft³/d
SCF/min SCF/m SCF/min
SCF/h SCF/h SCF/h
Nl/h Nl/h Nl/h
Nm3/h Nm3/h Nm³/h
Gal[UK]/Sec IGa/S gal (UK)/s
Gal[UK]/min IGa/m gal (UK)/min
Gal [UK]/h IGal/h gal (UK)/h
Gal[UK]/d IGa/d gal (UK)/d
Gal/Sec Ga/S gal/s
Gal/min Ga/m gal/min
Gal/h Ga/h gal/h
Gal/d Ga/d gal/d
Mgal/d MGI/d Mgal/d
bbl/d bbl/d bbl/d
bbl/h bbl/h bbl/h
bbl/min bbl/m bbl/min
bbl/Sec bbl/S bbl/s
Factory setting: m³/s
9.2.14.4 Mass flow units [16]
Selects the unit for the mass flow measurement.
This parameter is only visible when you have selected a mass flow characteristic curve using
the "Application" parameter.
Parameter assignment
9.2 Parameter assignment over device with display
SITRANS P320/P420 (mA/HART)
Operating Instructions, 06/2018, A5E44852162-AA 125