Siemens SITRANS Series - 9.2.13 SV selection [15]; 9.2.14 Units [16]; 9.2.14.1 Level units [16]

9.2.13 SV selection [15]
Sets a measured value as a secondary variable (SV).
Setting range: TEMP Sensor temperature
ETEMP Electronics temperature
LEVEL Level
VOL Volume
VFLOW Volume flow
USER Custom
MFLOW Mass flow
Factory setting: As specified in order
9.2.14 Units [16]
Introduction
Depending on the application of the device that you have selected using the "Application"
parameter, you have the option of selecting a unit:
● Level
● Volume
● Volume flow
● Mass flow
The selected unit is displayed in the measurement view.
Use the remote operation to set the associated unit for the "Customized characteristic curve"
application.
See also
Application [05] (Page 106)
9.2.14.1 Level units [16]
Selects the unit for the "Level" measurement.
Parameter assignment
9.2 Parameter assignment over device with display
SITRANS P320/P420 (mA/HART)
Operating Instructions, 06/2018, A5E44852162-AA 123