9.3.3 Identification
Define the data that you need to identify your device under the "Identification" parameter group.
A distinction is made between data you can set yourself and values that are preset in the
factory. The default values are write-protected and cannot be changed by the user. The
corresponding allocation is set out below:
Designation Adjustable Preset Factory setting
Short tag X -
Long tag (TAG) X -
Description X -
Message X -
Installation date X - dd.mm.yyyy
Device
Manufacturer_id - X Siemens
Product name - X SITRANS P420
1)
Article number - X e.g. 7MF0440-1GL01-5AF2-Z
1)
Order option 1/ Order option 2 - X e.g. A01+C11+C12+C14+C20+E00+H01+Y01+Y15+Y21
1)
Serial number - X in accordance with the measuring cell selection/device manufac‐
ture
Final assembly number X -
Sensor serial number - X in accordance with the measuring cell selection/device manufac‐
ture
Hardware version - X in accordance with the measuring cell selection/device manufac‐
ture
Firmware version - X in accordance with the measuring cell selection/device manufac‐
ture
EDD version - X
Sensor serial number - X in accordance with the measuring cell selection/device manufac‐
ture
Sensor type - X in accordance with the measuring cell selection/device manufac‐
ture
Maximum measuring span - X in accordance with the measuring cell selection/device manufac‐
ture
1)
in accordance with the order
9.3.4 Simulation
You can use the device to simulate the following via remote operation (e.g. field communicator,
SIMATIC PDM):
● Input and output values
– Constant pressure values
– Ramp function
● Diagnostics
Parameter assignment
9.3 Parameter assignment over remote operation
SITRANS P320/P420 (mA/HART)
Operating Instructions, 06/2018, A5E44852162-AA 143
To Next Page
Loading...
