Siemens SITRANS Series - 9.2.4.3 Volume and mass flow measurements

9.2.4.3 Volume and mass flow measurements
The following characteristic curves are available for volume and mass flow measurements:
● Hold at 0, square root (VSOFF, for volume or MSOFF, for mass flow)
The loop current is 4 mA up to the application point (low flow cut-off (Page 128)). Starting
from the application point, scaling occurs according to the square root:
$SSOLFDWLRQSRLQW
6HWWLQJUDQJH IRUDSSOLFDWLRQSRLQW







EDU
;
Y Loop current or flow
X Set measuring span
● Linear, square root (VSLN, for volume or MSLN, formass flow)
The loop current has a linear relationship with the differential pressure up to the application
point (Page 115). Starting from the application point, scaling occurs according to the square
root:
$SSOLFDWLRQSRLQW
OLQHDU
6HWWLQJUDQJH IRUDSSOLFDWLRQSRLQW






EDU

;
Y Loop current or flow
X Set measuring span
Parameter assignment
9.2 Parameter assignment over device with display
SITRANS P320/P420 (mA/HART)
Operating Instructions, 06/2018, A5E44852162-AA 111