Procedure
Switch on the power supply.
● Product name and firmware version appear briefly on the display.
● The measured values are shown on the display.
For a device without a display, you read off the current output as follows:
– Over the remote control (e.g. SIMATIC PDM).
– With a DC current measuring device.
Connecting the device (Page 62)
Result
The device is now ready for operation.
8.3 Commissioning the device with display
Introduction
In this section, you will learn how to commission the device step-by-step.
Before you start, please read the following safety information:
● General safety information (Page 19)
● Basic safety information: Installing/mounting
● Basic safety information: Connecting
● Basic safety information: Commissioning
Read the entire device manual in order to achieve the optimum performance of the device.
Procedure
1. Mount the device.
Installation (except level) (Page 43)
Installation (level) (Page 46)
2. Connect the device.
Connecting the device (Page 62)
3. Switch on the power supply.
Switching on the supply voltage (Page 84)
Commissioning
8.3 Commissioning the device with display
SITRANS P320/P420 (mA/HART)
Operating Instructions, 06/2018, A5E44852162-AA 85
To Next Page
Loading...
