Parame‐
ter ID
Parameter name on
the display
Meaning
06 SQRT POINT Application point for volume flow and mass flow (VSLN and MSLIN) (Page 115)
07 ZERO POINT Zero point adjustment (Page 116)
08 APPLY LRV Apply lower range value (with pressure applied) (Page 118)
09 APPLY URV Apply upper range value (with pressure applied) (Page 118)
10 FAULT CURR Select fault current (Page 120)
11 LO FAULT CUR Lower fault current (Page 120)
12 UP FAULT CUR Upper fault current (Page 121)
13 SATURAT LOW Lower saturation limit (Page 121)
14 SATURAT HI Upper saturation limit (Page 122)
15 SV SELECT SV selection, set secondary variable (Page 123)
16 LEVEL UNITS Level unit (Page 123)
16 VOL UNITS Volume units (Page 123)
16 VFLOW UNITS Volume flow units (Page 123)
16 MFLOW UNITS Mass flow units (Page 123)
17 TEMP UNITS Temperature units for sensor and electronics temperature (Page 126)
18 LOWER SCALNG Lower scaling point (Page 126)
19 UPPER SCALNG Upper scaling point (Page 128)
20 LOW FLOW CUT Low flow cut-off for volume flow and mass flow (VSOFF and MSOFF) (Page 128)
21 VESSEL DIM A Vessel dimension A (Page 129)
22 VESSEL DIM L Vessel dimension L (Page 129)
23 BUTTON LOCK Enable and disable button lock (Page 130)
24 CHANGE PIN Change user PIN (Page 131)
25 RECOVERY ID Display Recovery ID (Page 132)
26 PIN RECOVERY PIN recovery (Page 133)
27 USER PIN Enable and disable user PIN (Page 134)
28 DEVICE MODE Active device mode (Page 136)
29 FUNCT SAFETY Enable and disable Functional Safety (Page 136)
30 DISPLAY TEST Display test (Page 136)
31 LOOP TEST Loop test (Page 137)
32 START VIEW Start view (Page 138)
33 PRESSURE REF Pressure reference (Page 139)
34 IDENTIFY Identify the device (Page 139)
35 RESET Reset (Page 140)
1) The "Application" parameter is also called the "Transfer function" in certain configuration
tools.
Hereinafter, the parameter ID is always written inside parentheses after the parameter name.
Example: Parameter "Damping value" [04].
See also
Parameter assignment over device with display (Page 101)
Operating
7.2 Operating the device with display
SITRANS P320/P420 (mA/HART)
Operating Instructions, 06/2018, A5E44852162-AA 75
To Next Page
Loading...
