4. Open the cover of the buttons:
Figure 1-1 Top view
5. Set the measuring range.
Set lower range value/upper range value (without pressure available) (Page 104)
Apply lower range value/upper range value (with pressure present) (Page 119)
6. Set the pressure unit.
Setting the pressure units (Page 103)
7. Set the application of your device.
Set application (Page 115)
8. Set the scaling points.
Set lower scaling point (Page 127)
Set upper scaling point (Page 128)
9. Set the zero point.
Adjusting zero point (gauge pressure) (Page 116)
Adjusting the zero point (differential pressure) (Page 117)
Adjusting zero point (absolute pressure) (Page 117)
10.Lock the device.
Locking the device (Page 78)
11.Enable Functional Safety (for devices with Functional Safety).
Enabling Functional Safety over device with display (Page 160)
You can find additional functions in the section Parameter assignment (Page 97)
Getting Started
1.1 Commissioning the device with display
SITRANS P320/P420 (mA/HART)
12 Operating Instructions, 06/2018, A5E44852162-AA
To Next Page
Loading...
