Rotating the aluminum enclosure
1. Loosen the retaining screw ① by half a rotation.
2. Rotate the enclosure to the desired position (but no further than the end stop).
3. Tighten the retaining screw.
Rotating the stainless steel enclosure
1. Loosen the front retaining screw by half a rotation.
2. Loosen the back retaining screw by half a rotation.
3. Rotate the enclosure to the desired position (but no further than the end stop).
4. Tighten the front and back retaining screw.
To prevent the enclosure from turning in case of vibration, make sure that the front and
back retaining screw are tightened.
Installing/mounting
5.7 Rotating the enclosure
SITRANS P320/P420 (mA/HART)
58 Operating Instructions, 06/2018, A5E44852162-AA
To Next Page
Loading...
