Siemens SOMATOM Emotion syngo CT 2007E - Page 134

0.0
syngo CT 2007E Emotion Operator Manual
02/2008 0.0
Software Related Safety Information Safety
A.4-40
A.4
A.4
A.4
CAUTION A.4
Orientation of the object to be measured is not parallel to the
viewing plane of the screen!
A.4
Inaccurate measurement possible. A. 4
✧ To avoid measurement errors, perform the measurements
in MPR mode or on the clip planes only.
A.4
CAUTION A.4
Use of classification parameters to make a 3D image (window
width, level, opacity, etc.) affecting the apparent size of features
in the image!
A.4
Inaccurate measurement possible. A. 4
✧ Make sure that an appropriate set of classification parame-
ters is used when making measurements.