0.0
syngo CT 2007E Emotion Operator Manual
02/2008
0.0
Function Tests Operation
D.2-2
Performing the tests
D. 2
During the tests, the most important function procedures and
the safety equipment of the system are checked.
D. 2
Te s t i n g t h e k e y s o n g a n t r y o p -
erator panels
D. 2
You must check the following keys on the gantry operator pan-
els:
D. 2
❏ Gantry tilt
❏ Table positioning
❏ Predefined table position A and B
❏ Switching on the light marker
❏ Retracting the table
✧ Check the keys when you switch on the unit.
B
D.2
Press one key for motion control only at a time.
D. 2
The operating elements illustrated on the left margin in follow-
ing pages are from right gantry panel. You can use the operat-
ing elements on the left gantry panel as well.
D. 2
To Next Page
Loading...
