Simplex 4010 - Page 6

vi
Step 2. Define Digital Pseudo Point Attributes...................................... 2-18
Step 3. Add the Floor’s Initiating Devices to a List............................... 2-18
Step 4. Change the Point Type of NACs and Door Relays.................... 2-18
Step 5. Add the NACs and Door Relays to a List.................................. 2-18
Step 6. Add Appropriate NACs to List L6 (Off On Silence)................. 2-18
Step 7. Add Appropriate NACs to List L7 (Off On Reset).................... 2-19
Step 8. Add Custom Control Equations................................................. 2-19
Selective Activation of Single Station Devices........................................... 2-21
Introduction............................................................................................. 2-21
Step 1. Define Device Types, Point Types, and Mode for Single Station
Devices...................................................................................... 2-21
Step 2. Add Area’s Pull Stations to a User-Defined List....................... 2-21
Step 3. Add Custom Control Equations................................................. 2-21
Chapter 3. Suppression Release
Overview................................................................................................... 3-1
In this Chapter........................................................................................... 3-1
Default Suppression Release Applications ................................................... 3-2
Suppression Release Triggered by Single Pull Station or Automatic
Initiating Device.......................................................................... 3-2
Suppression Release Triggered by Dual Automatic Initiating Devices .... 3-2
Programming Default Applications .......................................................... 3-3
Dual Detector, Pre-Signal, and Abort Switch with No Delay....................... 3-5
Introduction............................................................................................... 3-5
Programming System Options, Point Types, and Lists............................. 3-6
Programming Custom Control.................................................................. 3-7
Dual Detector, Pre-Signal, and Abort Switch with Delay............................. 3-8
Introduction............................................................................................... 3-8
Define Lists, Digital Pseudos, and Analog Pseudos ................................. 3-9
Program Custom Control Equations ....................................................... 3-10
Chapter 4. Additional Applications
Overview................................................................................................... 4-1
In this Chapter........................................................................................... 4-1
Pre-Signal Operation..................................................................................... 4-2
Overview................................................................................................... 4-2
Step 1. Define NAC’s Device Type, Point Type, and Custom Label ...... 4-2
Step 2. Define Device Types, Point Types, and Custom Labels for
Initiating Devices ........................................................................ 4-3
Step 3. Add Initiating Devices and NACs to User-Defined Lists............ 4-3
Step 4. Add Appropriate NACs to List L6 (Off On Silence)................... 4-3
Step 5. Add Appropriate NACs to List L7 (Off On Reset)...................... 4-3
Step 6. Add Custom Control Equations................................................... 4-4
Programming a Utility Monitoring Point...................................................... 4-6
Overview................................................................................................... 4-6
Step 1. Change the Heat Detector’s Point Type and Custom Label......... 4-6
Step 2. Change the AUX Relay Point’s Point Type and Custom Label... 4-6
Step 3. Define a Supervisory Digital Pseudo Point.................................. 4-6
Step 4. Program Custom Control Equations ............................................ 4-6
Day / Night Programming............................................................................. 4-8
Overview................................................................................................... 4-8
Step 1. Program the Monitor Device’s Point Type, Device Type, and
Custom Label .............................................................................. 4-8
Technical Manuals Online! - http://www.tech-man.com