Singer 560 - Page 44

Pulling down the Ravel Cord tightly, move the Carriage
slowly to the other side, passed the end needle by 2-3cm.
Then continue to move the Carriage to and fro several
times.
Release the end of the Ravel Cord from the Yarn Clip,
and pull it out from the other end.
Cast-on (open edge) is completed.
Continue to knit in stockinet about 30 rows by moving the
Carriage back and forth.
Hang the Claw Weights on both sides of the fabric.
REMOVING THE FABRIC FROM THE
MACHINE
Take out the yarn from the Yarn Feeder, and cut it
above the Carriage.
Set the Cam Lever to 0 mark, and move it across the
needles.
The fabric will be released from the needles.
- 40 -