Singer 560 - Basic Knitting with Yarn Changer

(8) Depress both Pile Levers (marked blue) to widen
space between Knitter and Ribber Needle Bed.
(9) Knit from the left to the right.
If the yarns, pile yarn and ground yarn, get
entangled or loosened, pull the yarns back to yarn
balls
at the back of Auto- Tension before moving
Carriage.
- 8 Slide P Carriage on Ribber from the left to the
right.
- 9 Knit from the right to the left.
- 10 0 n Knitter, push 5 needles back to A position at
both sides of fabric to have plain edge for seaming.
8- 1 Slide P Carriage on Ribber from the left to the
right to push up needles to C position.
- 2 Set the Pattern Card and push 0 FF the fnspection
Button.
Knit 1 row from the left to right.
- 3 Slide P Carriage from the left to the right.
- 4 Knit 1 row from the right to the left.
- 5 Remove stitches on Knitter using P Carriage .
Then knit 1 row from left to right.
Repeat 8-3 - 8-5 for main knitting.
Suspend Hanger Combs with Weights after 10 rows and
advance them every 10 rows upwards.
To cut loops, spread fabric on a flat surface.
Insert one scissor blade into centre of loops and cut open .
Give steam to the surface of the fabric.
DO NOT PRESS.
- 85 -