Radio
Go to RADIO tab and choose the RC receiver protocol corresponding to the one you’re using. SBUS or PPM receivers are recommended. This
change will take effect after the system is restarted. Therefore, you will need to reboot the autopilot and connect again if you want changed to be
applied immediately.
Go to Settings > RADIO again and make sure that your RC radio is turned on. You’ll see the sticks positions displayed. Press CALIBRATE
button and move all sticks and switched of the radio to their end points.
When it’s done – press OK button to stop calibration and save parameters. You can remap any action to the desired channel and apply reverse if
needed.
To Next Page
Loading...
