Sky-Drones SMARTAP PRO - Flashing Bootloader; Tools Required; Connections

Drivers installation
Getting the software
Firmware update
General configuration
Standard PID presets
Updating GNSS Module
Flashing Bootloader
Tools required
Connections
Flashing
Flashing DFU (old)
Flashing Bootloader
Tools required
After manufactured boards come without bootloader pre-installed. You can easily flash them yourself. The tools which will be needed:
ST-Link v2 ARM JTAG Debugger
ARM JTAG Mini connector 1.25 mm pitch
Connections
ST Link debugger looks as following:
You will need to connect ST-Link pins to SmartAP Pins.
The reference for ST Link pins:
Introduction
SmartAP PRO
SmartAP MAX
SmartAP PDB
SmartAP GNSS
SmartLink
Autopilot configuration
Flying
Support
Revision history
SmartAP AutoPilot User’s Guide Flashing Bootloader
Sky-Drones - SmartAP Flight Control Systems 116 / 151