RTK GNSS
Specifications
This GNSS (GPS + GLONASS) module is base on RTK technology and was specially developed for SmartAP Autopilot and is intended to be
used in applications where precise positioning really matters. It's based on the latest and most precise UBlox Neo M8P chipset which provides
outstanding positioning accuracy. The set includes base station module with external active patch antenna, airborne module with integrated
patch antenna and set of cables.
Real Time Kinematic (RTK) satellite navigation is a technique used to enhance the precision of position data derived from satellite-based
positioning systems (global navigation satellite systems, GNSS). It uses measurements of the phase of the signal's carrier wave, rather than
the information content of the signal, and relies on a single reference station or interpolated virtual station to provide real-time corrections,
providing up to centimetre-level accuracy.
Features
Centimeter‑level GNSS positioning
Integrated Real Time Kinematics (RTK)
Smallest, lightest, and energy‑efficient RTK module
Complete and versatile solution due to base and rover variants
World‑leading GNSS positioning technology
UBlox NEO M8P chipset based
25mm ceramic patch antenna
GPS / GLONASS support
Up to 24 satellites
18 / 10 Hz update rate (GPS / GPS + GLONASS)
Rechargeable 3V lithium backup battery
Ultra-Low noise 3.3V regulator
Power and fix indicator LEDs
Exposed RX, TX, 5V and GND pads
Integrated magnetometer on airborne module - HMC5883L
UART port for GPS interface
USB for base station module
Airborne module cable length 30 cm
Base station module length 3 m
Fully compatible with SmartAP Autopilots
To Next Page
Loading...
