12
Skydio X2D INTL - Operator Manual © 2023 Skydio, Inc. All rights reserved.
Getting Started
Deploy Skydio X2D
Step 5 - Slide the battery on rails towards the camera until the magnets engage
Step 6 - Gently push the antennas inward to release
• Guide into a vertical position
Step 7 - Power on your Skydio X2D
• Press and hold the power button on the battery for 3 seconds
TIP: This is the suggested order of operations when assembling your X2D for the first time. It is not necessary to unfold
the X2D arms and antennas prior to installing the battery and powering on the drone. On subsequent deployments
insert the battery and power on the aircraft first, then unfold the arms and antennas while the drone is booting up.
To Next Page
Loading...
