Skydio X2D INTL - Update

15
Skydio X2D INTL - Operator Manual © 2023 Skydio, Inc. All rights reserved.
Getting Started
Update X2D System
Updates from Skydio contain important enhancements and fixes designed to improve performance, optimize flight
controls and features for the operation of your Skydio X2D oine system, Enterprise Controller, and Dual Charger.
You can update your vehicles and Enterprise Controller in any order, however it is important that you update the Dual
Charger last. You may use the same flash drive (or memory card reader) to update one system at a time or load the
update onto several flash drives for simultaneous updates.
There are two ways to receive the update package from
Skydio: SD memory card and secure download.
To update your Skydio X2D oine system you will need:
• a computer with an Internet connection
• a memory card reader with USB-C connection OR
a USB-C flash drive
• that has been authorized by command or IT Security
• formatted to exFAT file system
Step 1 - Insert the SD card that you received from Skydio
into a USB-C memory card reader
Step 2 - Insert the memory card reader into the USB-C
port on the vehicle
Step 3 - Power on the vehicle
• the update will begin automatically
• the lights on your drone will pulse blue
• the camera gimbal will disengage and go slack
• the process may take several minutes
• When the update is complete, the camera gimbal will re-engage
Step 4 - remove the USB-C flash drive
Update using a memory card