Skydio X2D INTL

To Next Page

To Previous Page

Step 5 - Tighten the tension bolt

• Using the torque driver

• Turn the driver clockwise until you hear a click indicating the

desired torque level has been achieved

Step 6 - Tighten the tension bolt set screw

• Turn the torque driver clockwise until you hear a click

indicating the desired torque level has been achieved

Step 7 - Repeat steps 1-6 on the remaining arms

Maintenance

Step 4 - Loosen the tension bolt set screw

• On the arm clamp tension bolt using the torque driver

Arm clamps

Skydio X2D INTL - Page 71