A-4
(3) The skyla
TM
Clinical Chemistry Analyzer sends the message body to the external
computer.
(4) The skyla
TM
Clinical Chemistry Analyzer sends the Close Command to external
computer.
(5) The external computer must respond with the acknowledge command. The skyla
TM
Clinical Chemistry Analyzer waits one second for the external computer to respond
with the acknowledge command. If the external computer does not respond with the
acknowledge command, the skyla
TM
Clinical Chemistry Analyzer will send the Close
command to the external computer. After timeout, the anaylzer system will go to step
(3). But it only retries one time. If the skyla
TM
Clinical Chemistry Analyzer still does
not receive the Acknowledge command from the external computer, the skyla
TM
Clinical Chemistry Analyzer will report an error message if the Export to RS232
function was triggered manually from the RECALL function. Test results will also
be exported to RS232 after analysis completion. In this case, no error message is
exported.
2.2 MESSAGE BODY FORMAT DEFINITION
The messages below will be sent to the external computer in sequence. The contents of
empty location are 0x20. Each message is ended by CR: 0x0D and LF: 0x0A.
(1) Model Name
1
2
3
4
5
6
7
8
9
1
0
1
1
1
2
1
3
1
4
1
5
1
6
1
7
1
8
1
9
2
0
2
1
2
2
2
3
2
4
2
5
2
6
2
7
2
8
2
9
3
0
M
o
d
e
l
N
a
m
e
X
X
X
X
X
X
X
X
X
C
R
L
F
Byte 16 to 24: Model name. The output is “Skyla HB1.”
(2) Panel Name
1
2
3
4
5
6
7
8
9
1
0
1
1
1
2
1
3
1
4
1
5
1
6
1
7
1
8
1
9
2
0
2
1
2
2
2
3
2
4
2
5
2
6
2
7
2
8
2
9
3
0
P
a
n
e
l
N
a
m
e
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
To Next Page
Loading...