SKYSHL SS413F Series - Cleaning LED in Light Bracket; Cleaning Objective Lens

106
Shenzhen Skyshl Technology Co.,LTD.
Sales email: sales1@skyshl.net After Sales email:af@skyshl.net Website:www.skyshl.net
SS413F Optical Fiber Fusion Splicer User’s Manual
V
Cleaning LED in light bracket
If two lads in the light bracket are dirty due to dust, the location of the optical fiber
core will not be accurate due to less light transparent degree. This is bound to cause
big splice loss. Clean the light according to the following steps: Remove dust from
the surface first with ear syringe. If the effect is not good, clean the surface of the
LED in the light bracket with fine cotton swabs dipped with alcohol(up and down
two holes perpendicular to the optical fiber clamp). Wipe off residual alcohol on
the light with dry cotton swabs as shown in the figure below.
5.4 Cleaning objective lens
If the objective lens become dirty, the normal observation position of the optical
fiber core may be affected, this will result in high splice loss or bad splicing. So
the operator shall regularly clean two objective lenses, otherwise, the dust will be
accumulated and eventually can not be removed.
5.4.1 Routine Maintenance