SKYSHL SS413F Series - Inspection and Maintenance; Cleaning V-Groove

104
Shenzhen Skyshl Technology Co.,LTD.
Sales email: sales1@skyshl.net After Sales email:af@skyshl.net Website:www.skyshl.net
SS413F Optical Fiber Fusion Splicer User’s Manual
V
5．Inspection and maintenance
The following describes the key points for cleaning and maintenance inspection.
5.1 Cleaning V-groove
If the V-groove is contaminated, it can not grip properly the optical fiber and this
will cause the splice loss too large. So in daily work, the V-groove should be
checked and cleaned periodically or regularly.V-groove cleaning steps are as
follows:
<1> Open the wind cover.
<2> Clean with a thin cotton swabs moistened with alcohol the bottom of V-groove,
and wipe off with a dry cotton swabs the alcohol left in the V-groove.
● When the left (right) motor is advanced by manual key to
the limit position, the motor will stop running.The operator
shall press manually the button to move the motor in the
opposite direction.
●
For the operation in section 5.1 ~ 5.5, turn off the
fusion splicer power.