Shenzhen Skyshl Technology Co.,LTD.
Sales email: sales1@skyshl.net After Sales email:af@skyshl.net Website:www.skyshl.net
SS413F Optical Fiber Fusion Splicer Userās Manual
V
special packing box (bag).
5.9.2 Adjustment of blade height
<1> Adjusting upwards the blade: The blade can not cut the fiber for a few
successive times, or the fiber end face has very irregular, cutting mark or
obvious cutting edge. It may be caused by insufficient height of the blade. Blade
height adjustment sequence is as follows: Use a wrench to loosen the height
locking screws on the cutter holder. Rotate the height adjusting screws in
clockwise a little as required, then tighten gently the height locking screws.
<2> Adjusting downwards the blade: The fiber end face after cutting has always
concave face, black spots, or angled etc. It may be caused by bladetoo high.
Blade height adjustment sequence is as follows:
Use a wrench to loosen the height locking screws on the cutter holder. Rotate
the height adjusting screws in counter clockwise a little as required, then tighten
gently the height locking screws.
5.9.3 Changing blade position
After height adjustment, the cutter can not cut off the fiber still for a few
successive times, or the fiber end face after cutting has very irregular cutting mark.
It may be caused by unsharp blade at simple point. It is necessary to change the
cutting position of the cutter blade. Hold the cutter blade with left hand. Loosen the
blade locking screws with a hex wrench (1.5mm) with right hand. Rotate the blade
to a new cutting point, then tighten the blade locking screw.
5.9.4 Replacement of blade
The average life of the blade is about 48,000 times of cutting To ensure the cutting
To Next Page
Loading...