Shenzhen Skyshl Technology Co.,LTD.
Sales email: sales1@skyshl.net After Sales email:af@skyshl.net Website:www.skyshl.net
SS413F Optical Fiber Fusion Splicer User’s Manual
V
coating layer of the tail fiber and wipe clean the fiber with alcoholic dust-free
paper. Notice: Reserve 0.9mm cladding for 3 ~ 4mm, 0.25 mm cladding for 3 ~ 4
mm also. Put the tail fiber into the cutter and cut it.
2.9 Placement of optical fiber
A.Open the wind cover and wait for the automatic reset of the fusion splicer until
the machine is at readiness status.
B.Put respectively the prepared fibers into the left and right clamps of the fusion
splicer.
C.Make ensure the optical fibers are placed at the bottom of the left and right V
grooves.
D.The end face of each fiber shall be placed between V-groove edge and the
electrode rod centerline.
●
The following is the application of different types of fibers in
FTTH projects:
Note the placement of 0.25mm
To Next Page
Loading...