Shenzhen Skyshl Technology Co.,LTD.
Sales email: sales1@skyshl.net After Sales email:af@skyshl.net Website:www.skyshl.net
SS413F Optical Fiber Fusion Splicer User’s Manual
V
B.Reserve 3-4mm coating and peel other fiber coating. Wipe clean the peeled
fiber cable with alcoholic dust-free paper.
C.Open the smaller steel plate and larger press plate at the left side of the cutter.
Put the stripped and clean fiber cable into the guide groove of the cutter and cut
the fiber cable. Put the fiber on the left or right clamp of the fusion splicer.
2.8.4 Production of end face of tail optical fiber
Follow the procedures above. Remove the outer cladding, tight cladding and
Note the placement of 0.25mm
● When the covered fiber cable is connected with a covered fiber cable,
one of the covered fibers shall be installed with a heat shrink sleeve
before stripping the clad.
To Next Page
Loading...