Shenzhen Skyshl Technology Co.,LTD.
Sales email: sales1@skyshl.net After Sales email:af@skyshl.net Website:www.skyshl.net
SS413F Optical Fiber Fusion Splicer User’s Manual
V
conducted. Through preheat splicing, the splicer automatically adapts to the
environment, automatically adapts to the oxidation of the arc electrodes. SM
optical fiber shall be used.Select "Calibrate - SM" splicing mode. Repeat 1 to 3
times of splicing. After the completion of preheat splicing, the operator can select
any kind of splicing modes required to splice the corresponding optical fiber.
B.If the splicer is transferred from the original low atmospheric pressure work
environment to the normal atmosphere working environment and the problem
"left, right optical fibers are burn into two balls" occurs continuously, and the
problems are not due to following reasons: the splicer press plate is loose;
optical fiber coating layer is peeled; optical fiber is broken; propeling structure
problem; high voltage power failure. “Clear real-time revise data” operation is
applicable to solve the problem of fiber "balling".
3.6.8 Open arc calibration (see section 3.4 of the manual)
In "Auto" and "Calibrate" splicing modes of SS413F splicer, in the full scope of
the work environment (including the combination of extreme working conditions),
the splicer has the functions of work environment self adaptive, electrode oxidation
self adaptive, real time splice arc control and calibration. Therefore, "shrink arc
calibration" function is stopped in the default factory setting. No "manual arc
calibration" is needed .
To Next Page
Loading...