Shenzhen Skyshl Technology Co.,LTD.
Sales email: sales1@skyshl.net After Sales email:af@skyshl.net Website:www.skyshl.net
SS413F Optical Fiber Fusion Splicer User’s Manual
V
"Auto - XX" mode has the automatic control and calibration function on strength
of splicing arc, also has the effect of preheat splicing, but the calibration action is
limited to this mode.
Use SM optical fiber and select "Auto - SM" as the present splicing mode. Repeat
1 to 3 times of preheat splicing. "Auto - SM" mode is up to the best condition now.
The operator can splice SM fiber in this mode.
"Auto - MM/ DS/NZ" modes are similar to "Auto - SM" modes (omitted).
4.1.2 Special precaution
SS413F optical fiber splicer, "Auto - XX" and "Calibrate - XX" splicing modes,
Has automatic splice arc strength control and calibration function in larger scope.
The control and calibration are closely related to optical fiber type. Therefore, The
fibers in "Auto - XX" and "Calibrate - XX" and the fiber to be spliced must be
same. Otherwise, Wrong calibration will occur. Seriously, The splicing will not be
conducted. After the error occurs, Under the condition the splicing is possible, Can
choose correct fiber, For "preheat splicing" to correct mistakes. If splicing is not
possible, The following methods shall be used for correcting mistakes:
A.Restore the factory setting,
As shown in following figure, move the cursor to "maintenance" window. Select
“Clear real-time revise data” and press button. The real-time revise data is
restored to the factory setting.
To Next Page
Loading...