Shenzhen Skyshl Technology Co.,LTD.
Sales email: sales1@skyshl.net After Sales email:af@skyshl.net Website:www.skyshl.net
SS413F Optical Fiber Fusion Splicer User’s Manual
V
2.8 Preparation of optical fiber end face
2.8.1 Installing optical fiber shrink sleeve
Before the fiber is not spliced, suit a fiber heat shrink sleeve on one fiber in
advance as shown in the figure below.
2.8.2 Production of single-mode and multimode fiber splicing end face
A. Open the big press plate of the cutter. Push the sliding block of the blade
from the rear end to the front end.
B. Strip off the fiber coating with fiber stripping pliers. The bare fiber length
reserved is 30-40mm. Wrap the fiber with absorbent cotton or cotton paper
dipped in alcohol. Then clean the bare fiber. Clean the fiber with absorbent
● Display brightness is set to be moderate and not too high so as to
reduce power consumption and extend the duration of lithium
batteries.
To Next Page
Loading...