Shenzhen Skyshl Technology Co.,LTD.
Sales email: sales1@skyshl.net After Sales email:af@skyshl.net Website:www.skyshl.net
SS413F Optical Fiber Fusion Splicer Userās Manual
V
operation of the fiber splice.
<2> When the machine is delivered, in "Select splice parameter files" menu, in
number 1 to 8 splice parameter files, there are 9 operating parameters and
options for the user to edit and select. In numbers 9 to 12 splice parameter files,
there are 15 operating parameters and options for the user to edit and select;
<3> According to splicing demand, the user can select and edit the current"splice
parameter files".For specific steps and requirements, please refer to "3.2.2edit/
select" of the manual.
4.4 Fusion splicing operation
SS413F fusion splicer is provided with an image processing system to observe
and inspect the optical fiber.However, in some cases, the image processing
system may not discover fusion splicing errors. To achieve good splicing results,
the operator requires using the display to monitor visually the entire splicing
process of the optical fiber. The following describes the standard splicing steps.
4.4.1 Inspection of optical fiber cleave angle and end face of optical fiber
<1> Two optical fibers are loaded into the fusion splicer and are moved near. After
cleaning discharge, two optical fibers are stopped respectively at a set position.
Then check the cleave angle and the quality of the end face of each fiber. If the
measured fiber cleave angle is bigger than the set limit (factory default value)
and the end face of the optical fiber is found to have burrs, the machine alarms,
at the same time, the display will show a overrun alarm message. Fiber splicing
To Next Page
Loading...