Shenzhen Skyshl Technology Co.,LTD.
Sales email: sales1@skyshl.net After Sales email:af@skyshl.net Website:www.skyshl.net
SS413F Optical Fiber Fusion Splicer User’s Manual
V
●
If AC voltage of the mains power (or generator) is lower than 100V or higher
than 240V or unstable, AC / DC power adapter will not provide normal DC
output. DC output cable of the power adapter can not be connected to "DC IN"
input of the fusion splicer.
2.1.2 Power supply by lithium battery
The lithium battery in this machine is an "independent removable battery":If the
fusion splicer will not be used for a long time, the battery must be removed from
the splicer for safety concern. When the splicer is going to be used again, the
battery can be installed to the splicer quickly, realizing "charging battery while
working". The battery can always be charged directly on-line and the service life
of the battery can be prolonged thereby.
A.Lithium battery installation and power supply
As shown in the figure below, hold the splicer with and with the bottom facing
upward, "independent removable battery" is installed at the bottom of the
splicer. As indicated by the arrow, the splicer is powered by the "independent
Do not use external power supply which does not meet the
requirements of our company,otherwise it will burnout fusion splicer
or cause personal injury. When the AC/DC power supply adapter input
cable is connected to AC220V, 50 / 60HZ power supply, the user must
use an effectively grounded three-holes socket.
To Next Page
Loading...