SKYSHL SS413F Series - Production of the Fusion Splicing End Face of Covered Optical Cable

24
Shenzhen Skyshl Technology Co.,LTD.
Sales email: sales1@skyshl.net After Sales email:af@skyshl.net Website:www.skyshl.net
SS413F Optical Fiber Fusion Splicer User’s Manual
V
E. Hold the cutter with the left hand. Open the bigger press plate of the cutter with
the right hand and remove the waste fiber. Put the waste fiber into a fixed
container.
F. Open the smaller steel plate of the cutter with the right hand and hold the fiber
with the left hand at same time. Remove carefully the fiber with chopped neat
end face. Notice: Neat end face of the fiber shall not touch any item. Put the fiber
on the left or right clamp of the fusion splicer.
2.8.3 Production of the fusion splicing end face of covered optical cable
A.Put in advance a heat-shrink sleeve on the covered fiber cable before peeling the
cover. Put about 50mm of the covered fiber cable into the stripper for peeling the
cover.
Penetrate the heat shrink sleeve as
indicated by the arrow.