Shenzhen Skyshl Technology Co.,LTD.
Sales email: sales1@skyshl.net After Sales email:af@skyshl.net Website:www.skyshl.net
SS413F Optical Fiber Fusion Splicer Userās Manual
V
cotton or cotton paper only once. Do not use same absorbent cotton or cotton
paper to wipe the fiber for the second time.
(Note: Please use alcohol with purity higher than 99%).
C.Open the smaller steel plate at the left side of the cutter and put horizontally the
stripped and cleaned fiber in the guide groove of the cutter. Hold down the
smaller steel plate with left hand and close the bigger press plate of the cutter
with right hand. It is required that the bare fiber is put straightly on the left and
right fiber rubber pressing seats.
D. Hold the cutter with left hand. Then push the sliding block of the cutter blade to
the other end with the right hand to cut the fiber.
Note the placement of 0.25mm
To Next Page
Loading...