Shenzhen Skyshl Technology Co.,LTD.
Sales email: sales1@skyshl.net After Sales email:af@skyshl.net Website:www.skyshl.net
SS413F Optical Fiber Fusion Splicer User’s Manual
V
<3> Quality of the fiber end face has a great influence on the splice loss, so when
cleaving the fiber, the operator shall try to make the fiber end face in a plane, and
the angle of the plane with the cross section of the fiber is less than 1°. The end
face in the following figure (a) is good and can be sliced; (b) ~ (f) are undesirable
end facesand they shall be made again.
4.4.2 Automatic alignment and fusion splicing
After optical fiber inspection is complete, the fibers will be aligned according to
the manner of "core to core" or "clad to clad". Then produce the arc and splice the
fibers.
To Next Page
Loading...