Shenzhen Skyshl Technology Co.,LTD.
Sales email: sales1@skyshl.net After Sales email:af@skyshl.net Website:www.skyshl.net
SS413F Optical Fiber Fusion Splicer User’s Manual
V
wer supply by power adapter
<1>The basic parameters of the exclusive AC/DC power adapter of the fusion
splicer produced by our company :
INPUT: AC100-240V ~ 1.8A 50 / 60HZ OUTPUT: DC13.5V / 4.8A
<2>Power supply of the power adapter is shown as follows:No power connector is
required at the bottom of the splicer. The power adapter is connected to AC
mains power.Finally, DC output power cable is connected to "DC IN" inlet of
the power supply at the right side of the fusion splicer. The fusion splicer is
powered then by the power adapter.
● Use only AC adapter power cable supplied with the machine.
● The ground terminal of AC input power cable must be effectively
grounded.
●
When using AC generator, the operator shall check regularly whether
it conforms to AC input requirements of the output voltage.
●
Use only DC output power cable supplied with the adapter.
●
Strictly prohibit to handle AC power cable, adapter and fusion
splicerwith wet hand,or an electrical shock may be caused.
To Next Page
Loading...