Shenzhen Skyshl Technology Co.,LTD.
Sales email: sales1@skyshl.net After Sales email:af@skyshl.net Website:www.skyshl.net
If [splice operation] "automatic start" is set to "On" : "Auto
fiber move forward" setting is invalid, the fiber will be
spliced automatically when the wind cover is closed.
If "automatic start" is set to "No" :
A."Auto fiber move forward" is set to "On" status:When
closing the wind cover, the fiber is pushed into the screen.
Press button again. The fiber is spliced automatically.
B." Auto fiber move forward" is set to "No" status: When
closing the wind cover, the fiber does will not go into the
screen. Press button, the fiber is spliced automatically.
It is set to "On": If the fiber end face cleaved exceeds the
limit value, the screen shows respectively "red unfilled
corner" overrun alarm message on the left and right fiber
end faces.
To Next Page
Loading...