SMC Networks LECSA Series - Page 46

- 44 -
(2) Symbol allocation using the setup software:
Changing pins CN1 – 4 from servo-on (SON) to gain switch (CDP):
① Change PD05 from 0202 to 0211 in the I/O tab.
② Click on the "Single Axis Write" button.
③ Cycle the power off, then on for the parametersto be enabled..
※ Please allocate pins CN1-4 separately.
※ See “LECSA Operation Manual”, section 4.4.2 for details on allocation of input signals to pins CN1-3 -
CN1-8.
※ See “LECSA Operation Manual”, section 4.4.2 for details on allocation of Output signals to pins CN1-9 -
CN1-12.
②
①
0202
↓
0211