SMC Networks LECSA Series - Setting a Maximum of 7 Points Using the Point Table in Positioning Mode (Point Table)

- 45 -
5.5.5 Setting a Maximum of 7 Points using the Point Table in Positioning mode (Point Table)
The point table can reach a maximum of 7 points using input signals DI0, DI1 and DI2.
The default allocation, allocates signals DI0 to (CN1-5) and DI1 to (CN1-23).
Note – CN1-23 can only be used if the input is configured as current sink NPN
8 points can be specified , however 1 point is reserved for the home position return, 7 points can be specified
in the point table.
When using a maximum of 7 point tables, wiring and input signal allocation of the DI2 must be implemented.