SMC Networks LECSA Series - Initial I;O Signal Allocation

- 41 -
5.5.2 Initial I/O Signal Allocation
(1) Position control mode (pulse input):
The initial (Default) allocation of I/O signals is shown below.
See “LECSA Operation Manual”, section 3.5 and “LECSA Operation Manual”,section 3.6 for details regarding
signals.
See “LECSA Operation Manual”, section 4.4.2 for parameter configuration values.
※ Pins CN1-23 and CN1-25 are pulse input terminals. These cannot be allocated as any other input
signals.
※ Pins CN1-3 - CN1-8 (input signals) and CN1-9 - CN1-12 (output signals) can be allocated as current Sink
(NPN) interface and current Source (PNP) interface wiring and I/O signal allocation.
(2) Positioning mode:
The initial allocation of the I/O signals is shown below.
See “LECSA Operation Manual”, section 13.2.3 for details regarding signals.
See “LECSA Operation Manual”, section 4.4.2 for details on parameter setting values.
※ Pins CN1-23 and CN1-25 can be allocated in current Sink (NPN) interface interface wiring and I/O
signal allocation only.
※ Pins CN1-3 and CN1-8 (input signals) and CN1-9 ~ CN1-12 (output signals) can be allocated in
currect Sink (NPN) interface and current Source (PNP) interface wiring and I/O signal
allocation.
PD02 to PD14 Input signal assignment (CN1-23, CN1-25, CN1-3 to CN1-8)
PD15 to PD18 Output signal assignment (CN1-9 to CN1-12)
Input signal points (6): (position control mode) and initial assignment
Output signal points (4) (position control mode) and initial assignment
Input signal points (8): (positioning mode) and initial assignment
Output signal points (4): (positioning mode) and initial assignment
PD03 to PD14 Input signal assignment (CN1-3 to CN1-8)
PD15 to PD18 Output signal assignment (CN1-9 to CN1-12)