196
Maintenance Diagnostic Tool
Replacing the Battery Pack
If the battery pack no longer holds a charge, contact your sales representative to order a new one.
Replace the battery pack with a Snap-on replacement battery pack only.
z To replace the battery pack:
1. Loosen the two battery pack screws.
2. Carefully tilt the battery pack up from the bottom, and then remove it.
1— Battery Pack
2— Battery Pack Screws (2)
Figure 17-1 Battery pack location
3. In the opposite manner of removal; insert the new battery pack into position, then tilt it down
into place making sure it is fully seated.
i Do not overtighten the battery pack screws.
4. Tighten the two battery pack screws.
To Next Page
Loading...
