148
Data Manager Operations Operations
12.3.9 Email
Selecting the Email icon from the Data Manager toolbar allows you to send a saved data or image
file as an attachment using e-mail. To use this feature, you must install an e-mail client, and then
either link your existing e-mail address to the client, or create a new address. The following
instructions are intended as a guide only.
z To attach a file from a Data Manager folder to an e-mail:
i The Email feature uses your system default email client. Refer to Windows Help for instructions on
setting your default e-mail client. For an example on how to setup an e-mail client, see E-mail
client installation and setup (Example): on page 149.
1. From the Data Manager main screen, select a file from within one of the folders (e.g. Camera,
Scanner Data, Scope Multimeter, etc). In this example (Figure 12-7). a Vehicle Systems
Report was chosen from the Vehicle Systems Report Data Folder.
2. With the file highlighted, select Email from the toolbar.
Figure 12-7
3. A new e-mail message window displays with the selected file attached (Figure 12-8).
i If the e-mail message window does not appear, check the Windows taskbar.
To Next Page
Loading...
Need help?
General
