SIP Phone Configuration Guide
- 12 -
3.2.1.1 General Account Settings
Click the links on the web portal for each setting to see the matching configuration file parameter in
Section 6.6 Configuration File Parameter Guide. Default values and ranges are listed there.
Enable or disable the SIP account. Select to enable.
Enter the name that will appear on the HD10X cordless handset
display when account 1 is selected.
The Account Label identifies the SIP account throughout the Web
Portal and on the handset Line menu.
Enter the Display Name. The Display Name is the text portion of the
caller ID that is displayed for outgoing calls using account 1.
Enter the User identifier supplied by your service provider.
The User ID, also known as the Account ID, is a SIP URI field used
for SIP registration.
Note:
• Do not enter the host name (e.g. "@sipservice.com"). The Web
Portal automatically adds the default host name.
If authentication is enabled on the server, enter the authentication
name (or authentication ID) for authentication with the server.
If authentication is enabled on the server, enter the authentication
password for authentication with the server.
Enter the dial plan, with dialing strings separated by a symbol. See
Section 3.2.1.2 Dial Plan.
Call Restriction Dial plan
To restrict users from dialing out numbers through dial plan matching
on a per-account basis.
Inter Digit Timeout (sec)
Set how long the HD10X waits after any "P" (pause) in the dial string
or in the dial plan.
Select the line type to Private or Shared.
A private line will be accessible only at the HD10X you are
configuring. Shared lines can be assigned to more than one HD10X.
For more information about using shared lines, see HD10X User
Guide.
Select the default DTMF transmission method. You may need to
adjust this if call quality problems are triggering unwanted DTMF
tones or you have problems sending DTMF tones in general.
Enable the phone to unregister the account(s) after rebooting - before
the account(s) register again as the phone starts up. If other phones
that share the same account(s) unregister unexpectedly in tandem
with the rebooting HD10X, disable this setting.
3.2.1.2 Dial Plan
The dial plan consists of a series of dialing rules, or strings, that determine whether what the user has
dialed is valid and when the HD10X should dial the number.
Dialing rules must consist of the elements defined in the table below.
To Next Page
Loading...
