- 65 -
◼ Redirect server
To configure your phone using the TFTP Pull Down Method:
Please see Chapter 4 Configure via Star Code for complete information of how enter star codes.
If a DHCP option 66 server is present:
◼ The phone will do a GET request for the configuration file from the DHCP option 66 server.
For example, DHCP option 66 server address = 192.168.1.200, the phone will do a GET request
for 192.168.1.200/1388.cfg.
◼ Your phone will reboot after installing the configuration file.
If you do NOT have DHCP option 66:
◼ The phone will do a GET request for the configuration file from the Redirection server.
For example, Redirection server address = https://provisioning.snom.com/hotel01/, the phone
will do a GET request for https:// provisioning.snom.com/hotel01/1388.cfg
◼ Your phone will reboot after installing the configuration file.
6.6 Configuration File Parameter Guide
This chapter lists the available options for all the settings within the HD10X configuration file. Most
settings in the configuration file have an equivalent in the Web Portal (see the settings tables in Chapter
3 Configure via Web Portal). However, the options you must enter when editing the configuration file
have a different syntax and format.
The settings are divided into modules. Most modules correspond to a page on the HD10X Web Portal.
You may wish to reorganize the modules within the configuration file itself. The configuration file settings
can be listed in any order, and the configuration file will still be valid.
The modules included in the configuration file are:
6.6.1 SIP Account Settings ("sip_account" Module)
The SIP Account settings enable you to set up individual accounts for each user. Each account requires
you to configure the same group of SIP account settings. The SIP account settings for each account
are identified by the account number.
For example, for account 1 you would set:
sip_account.1.sip_account_enable = 1
sip_account.1.label = Line 1
sip_account.1.display_name = 1001
sip_account.1.user_id = 2325551001
and so on.
For account 2, you would set:
sip_account.2.sip_account_enable = 1
sip_account.2.label = Line 2
sip_account.2.display_name = 1002
sip_account.2.user_id = 2325551002
and so on, if you have additional accounts to configure.
To Next Page
Loading...
